Nodular cast iron fatigue lifetime in cyclic plane bending
|
Title | Nodular cast iron fatigue lifetime in cyclic plane bending |
Authors | |
Abstract | The fatigue behavior of a component is strongly dependent on the material and its surface condition. Therefore, the manner in which the surface is prepared during component manufacturing (surface roughness, residual stresses etc.) has a decisive role in dictating the initiation time for fatigue cracks. The fatigue behavior of the same material, a nodular cast iron, with three different surface conditions (fine ground, sand blast and as-cast) has been investigated under cyclic plane bending. The results show differences in fatigue strength, which are associated with the surface conditions. The characteristics of the surface layers of the different test specimens were examined by metallography. |
Publisher | Faculty of Mechanical Engineering University of Zilina, Slovak Republic |
Date | 2012-05-02 |
Source | Materials Engineering - Materiálové inžinierstvo (MEMI) Vol 19, No 3 (2012) |
Rights | Articles published in this Open Acess Journal are licensing using Creative Commons License. Except where otherwise noted, individual articles in the Materials Engineering - Materiálové inžinierstvo journal are licensed under a CREATIVE COMMONS ATTRIBUTION-NON COMMERCIAL-NO DERIVS 3.0 UNPORTED LICENSE (for details please visit http://creativecommons.org/licenses/by-nc-nd/3.0/ ).Copyrights for articles published in Materials Engineering - Materiálové inžinierstvo (MEMI) journal are retained by the authors, with first publication rights granted to the journal. The journal/publisher is not responsible for subsequent uses of the work.Authors are permited to self-archive the final version of their published articles into institutional repositories. Authors can use the final version of published article for the non-exclusive distribution with an acknowledgement of its previous publication in this journal.Authors are allowed to post their work to institutional repositories prior to and during the submission (evaluation) process. |