UTILIZATION OF STEREOLOGY FOR QUANTITATIVE ANALYSIS OF PLASTIC DEFORMATION OF FORMING PIECES
|
| Title | UTILIZATION OF STEREOLOGY FOR QUANTITATIVE ANALYSIS OF PLASTIC DEFORMATION OF FORMING PIECES |
| Authors | |
| Abstract | Mechanical working leads to final properties of forming pieces, which are affected by conditions of production technology. Utilization of stereology leads to the detail analysis of three-dimensional plastic deformed material structure by different forming technologies, e.g. forging, extruding, upsetting, metal spinning, drawing etc. The microstructure of cold drawing wires was analyzed. Grain boundaries orientation was measured on the parallel section of wire with a different degree of deformation and direct axis plastic deformation was evaluated in bulk formed part. The strain of probes on their sections was obtained using stereology by measurement of degree of grain boundary orientation which was converted to deformation using model of conversion of grain boundary orientation degree to deformation. |
| Publisher | Faculty of Mechanical Engineering University of Zilina, Slovak Republic |
| Date | 2012-01-21 |
| Source | Materials Engineering - Materiálové inžinierstvo (MEMI) Vol 19, No 1 (2012) |
| Rights | Articles published in this Open Acess Journal are licensing using Creative Commons License. Except where otherwise noted, individual articles in the Materials Engineering - Materiálové inžinierstvo journal are licensed under a CREATIVE COMMONS ATTRIBUTION-NON COMMERCIAL-NO DERIVS 3.0 UNPORTED LICENSE (for details please visit http://creativecommons.org/licenses/by-nc-nd/3.0/ ).Copyrights for articles published in Materials Engineering - Materiálové inžinierstvo (MEMI) journal are retained by the authors, with first publication rights granted to the journal. The journal/publisher is not responsible for subsequent uses of the work.Authors are permited to self-archive the final version of their published articles into institutional repositories. Authors can use the final version of published article for the non-exclusive distribution with an acknowledgement of its previous publication in this journal.Authors are allowed to post their work to institutional repositories prior to and during the submission (evaluation) process. |