Determination of the optimal tempering temperature in hard facing of the forging dies
|
| Title | Determination of the optimal tempering temperature in hard facing of the forging dies |
| Authors | |
| Abstract | Here is analyzed selection of the optimal technology for heat treatment during the reparation of the damaged forging dies. Those tools are manufactured from alloyed tool steels for operation at elevated temperatures. Those steels are prone to self-hardening, so in reparatory hard-facing they must be preheated, additionally heated and tempered. During the tempering, in temperature interval 500-600°C, a secondary increase of hardness and decrease of impact toughness occurs, the so-called reversible tempering brittleness. Here is shown that it can be avoided by application of metallurgical and technological measures. Metallurgical measures assume adequate selection of steels. Since the considered steels are per se prone to tempering brittleness, we conducted experimental investigations to define the technological measures to avoid it. Tests on models were conducted: tempering from different temperatures, slow heating and cooling in still air. Hardness measurements showed that at 520°C, the secondary increase of hardness occurs, with drop of the impact toughness. Additional hard-facing tests included samples tempered at various regimes. Samples were prepared for mechanical and metallographic investigations. Results presented illustrate influence of additional heat treatment on structure, hardness and mechanical properties of the hard-faced layers. This enabled establishing the possibility of avoiding the tempering brittleness through technological measures. |
| Publisher | Faculty of Mechanical Engineering University of Zilina, Slovak Republic |
| Date | 2012-05-02 |
| Source | Materials Engineering - Materiálové inžinierstvo (MEMI) Vol 19, No 3 (2012) |
| Rights | Articles published in this Open Acess Journal are licensing using Creative Commons License. Except where otherwise noted, individual articles in the Materials Engineering - Materiálové inžinierstvo journal are licensed under a CREATIVE COMMONS ATTRIBUTION-NON COMMERCIAL-NO DERIVS 3.0 UNPORTED LICENSE (for details please visit http://creativecommons.org/licenses/by-nc-nd/3.0/ ).Copyrights for articles published in Materials Engineering - Materiálové inžinierstvo (MEMI) journal are retained by the authors, with first publication rights granted to the journal. The journal/publisher is not responsible for subsequent uses of the work.Authors are permited to self-archive the final version of their published articles into institutional repositories. Authors can use the final version of published article for the non-exclusive distribution with an acknowledgement of its previous publication in this journal.Authors are allowed to post their work to institutional repositories prior to and during the submission (evaluation) process. |